Viewing file:  extcon-adc-jack.h (2.19 KB) -rw-r--r--
Select action/file-type:
 (+) |  (+) |  (+) | Code (+) | Session (+) |  (+) | SDB (+) |  (+) |  (+) |  (+) |  (+) |  (+) |
/* SPDX-License-Identifier: GPL-2.0-only */
/*
* include/linux/extcon/extcon-adc-jack.h
*
* Analog Jack extcon driver with ADC-based detection capability.
*
* Copyright (C) 2012 Samsung Electronics
* MyungJoo Ham <myungjoo.ham@samsung.com>
*/
#ifndef _EXTCON_ADC_JACK_H_
#define _EXTCON_ADC_JACK_H_ __FILE__
#include <linux/module.h>
#include <linux/extcon.h>
/**
* struct adc_jack_cond - condition to use an extcon state
* denotes the last adc_jack_cond element among the array)
* @id: the unique id of each external connector
* @min_adc: min adc value for this condition
* @max_adc: max adc value for this condition
*
* For example, if { .state = 0x3, .min_adc = 100, .max_adc = 200}, it means
* that if ADC value is between (inclusive) 100 and 200, than the cable 0 and
* 1 are attached (1<<0 | 1<<1 == 0x3)
*
* Note that you don't need to describe condition for "no cable attached"
* because when no adc_jack_cond is met, state = 0 is automatically chosen.
*/
struct adc_jack_cond {
unsigned int id;
u32 min_adc;
u32 max_adc;
};
/**
* struct adc_jack_pdata - platform data for adc jack device.
* @name: name of the extcon device. If null, "adc-jack" is used.
* @consumer_channel: Unique name to identify the channel on the consumer
* side. This typically describes the channels used within
* the consumer. E.g. 'battery_voltage'
* @cable_names: array of extcon id for supported cables.
* @adc_contitions: array of struct adc_jack_cond conditions ending
* with .state = 0 entry. This describes how to decode
* adc values into extcon state.
* @irq_flags: irq flags used for the @irq
* @handling_delay_ms: in some devices, we need to read ADC value some
* milli-seconds after the interrupt occurs. You may
* describe such delays with @handling_delay_ms, which
* is rounded-off by jiffies.
* @wakeup_source: flag to wake up the system for extcon events.
*/
struct adc_jack_pdata {
const char *name;
const char *consumer_channel;
const unsigned int *cable_names;
/* The last entry's state should be 0 */
struct adc_jack_cond *adc_conditions;
unsigned long irq_flags;
unsigned long handling_delay_ms; /* in ms */
bool wakeup_source;
};
#endif /* _EXTCON_ADC_JACK_H */
|